INSPECTION
PROCEDURE
1. INSPECT SIDE AUTO STEP MOTOR ASSEMBLY
(a) Check that the motor gear rotates smoothly as follows. NOTICE: Do not apply positive (+) battery voltage to any terminals except terminal 5 and 4 to avoid damaging the pulse sensor inside the motor. OK:
CAUTION: Reset the side auto step motor assembly (initialize the pulse sensor) after installing the side auto step motor assembly and side auto step assembly. Text in Illustration
|
|
Messages displayed on the accessory meter
Depending on switch operation, one of the following messages may appear on
the accessory meter to provide guidance on transfer mode selection etc:
Multi-terrain Select is temporarily canceled when
The front-wheel drive control lever or switch is shift ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. REMOVE FRONT WHEEL
2. DISCONNECT FRONT DISC BRAKE CYLINDER ASSEMBLY LH
3. REMOVE FRONT DISC
4. REMOVE FRONT AXLE HUB GREASE CAP
5. INSPECT FRONT AXLE HUB BEARING LOOSENESS
(a) Using a dial indicator ...