Toyota 4Runner: Inspection

Toyota 4Runner Service Manual / Vehicle Exterior / Wiper / Washer / Rear Wiper Motor / Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR WIPER MOTOR AND BRACKET ASSEMBLY

(a) Check the wiper intermittent operation.

(1) Connect the positive (+) lead of the battery to terminal 5 (L) and the negative (-) lead to terminal 4 (E), and check that the motor operates.

OK:

Motor operates.

Text in Illustration

*1	Component without harness connected (Rear Wiper Motor and Bracket Assembly)

If the result is not as specified, replace the rear wiper motor and bracket assembly.

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ). 2. RE ...

Installation

INSTALLATION PROCEDURE 1. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY (a) Attach the 2 guides and temporally install the rear wiper motor and bracket assembly with the 3 bolts. ...

Other materials about Toyota 4Runner:

Freeze Frame Data
FREEZE FRAME DATA 1. FREEZE FRAME DATA (a) Whenever a DTC is stored, the skid control ECU stores the current vehicle (sensor) state as freeze frame data. (b) The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turn ...

IG2 Signal Malfunction (B2788)
DESCRIPTION The steering lock ECU determines the on/off status of the engine switch through the IG2 signal circuit. The steering lock ECU does not lock the steering when it receives the IG2 relay on signal. This prevents the steering from being locked wh ...