INSPECTION
PROCEDURE
1. INSPECT LEVEL WARNING SWITCH ASSEMBLY
HINT:
The following check should be performed with the windshield washer motor and pump installed to the washer jar.
(a) Fill the washer jar with washer fluid.
(b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
HINT: When the fluid volume is between 630 and 830 cc (38.4 cu.in. and 50.6 cu.in.), the level warning switch may be on or off. Text in Illustration
If the result is not as specified, replace the level warning switch assembly. |
|
Steering Angle Sensor Zero Point Malfunction (C1290)
DESCRIPTION
The skid control ECU acquires steering angle sensor zero point every time the
ignition switch is turned to ON and the vehicle is driven at 40 km/h (25 mph) or
more for approximately 10 seconds. The ECU also stores the previous zero point.
If ...
Ambient Temperature Sensor
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT COOLER THERMISTOR (AMBIENT TEMPERATURE SENSOR)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Con ...