INSPECTION
PROCEDURE
1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
(a) Remove the washer jar.
(b) Disconnect the windshield washer motor and pump connector.
HINT:
Make sure that the windshield washer motor and pump is installed to the washer jar.
(c) Fill the washer jar with washer fluid.
(d) Connect the positive (+) lead of the battery to terminal 1 of the windshield washer motor and pump and the negative (-) lead to terminal 2. |
|
(e) Check that washer fluid flows from the washer jar.
OK:
Washer fluid flows from the washer jar.
If the result is not as specified, replace the washer motor and pump assembly.
Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown.
If this happens, check and replace the fuses as necessary.
Vehicles without a smart key
system Turn the engine switch off. Vehicles with a smart key
system
Turn the “ENGINE ...
Power Seat Position is not Memorized
DESCRIPTION
When the seat memory SET switch and a memory switch (M1 or M2) are pressed simultaneously,
the main body ECU commands the position control ECU through CAN communication to
record the value of each position sensor.
WIRING DIAGRAM
CAUTION / ...