INSPECTION
PROCEDURE
1. INSPECT REAR DOOR LOCK ASSEMBLY LH
(a) Check the door lock motor operation.
(1) Apply battery voltage to the door lock motor and check the operation of the door lock motor. OK:
If the result is not as specified, replace the rear door lock assembly. Text in Illustration
|
|
(b) Check the detection switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
6 (LSSR) - 9 (E) |
Lock |
10 kΩ or higher |
6 (LSSR) - 9 (E) |
Unlock |
Below 1 Ω |
If the result is not as specified, replace the rear door lock assembly.
2. INSPECT REAR DOOR LOCK ASSEMBLY RH
(a) Check the door lock motor operation.
(1) Apply battery voltage to the door lock motor and check the operation of the door lock motor. OK:
If the result is not as specified, replace the rear door lock assembly. Text in Illustration
|
|
(b) Check the detection switch.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
6 (LSSR) - 9 (E) |
Lock |
10 kΩ or higher |
6 (LSSR) - 9 (E) |
Unlock |
Below 1 Ω |
If the result is not as specified, replace the rear door lock assembly.
Installation
INSTALLATION
PROCEDURE
1. INSTALL STEERING WHEEL ASSEMBLY
(a) Align the matchmarks on the steering wheel assembly and steering main shaft
assembly.
(b) Install the steering wheel assembly set nut.
Torque:
50 N·m {510 kgf·cm, 37 ft·lbf}
2. INSTALL ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL PARKING PEDAL PAD
(a) Install the parking pedal pad.
2. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY
(a) Temporarily install the No. 1 parking brake cable assembly with the adjusting
nut and lock nut.
(b) Install the No. ...