Toyota 4Runner: Inspection

Toyota 4Runner Service Manual / Vehicle Interior / Door Lock / Wireless Door Lock Buzzer / Inspection

INSPECTION

PROCEDURE

1. INSPECT WIRELESS DOOR LOCK BUZZER

(a) Measure the resistance according to the value(s) in the table below.

HINT:

The buzzer activation circuit is built into the ECU, not into the buzzer itself. When battery voltage is applied directly to the buzzer, the buzzer will not sound.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 - 2	Always	285 to 315Ω

If the result is not as specified, replace the wireless door lock buzzer.

Text in Illustration

*a	Component without harness connected (Wireless Door Lock Buzzer)

Removal

REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL 2. REMOVE FRONT FENDER MUDGUARD LH (w/o Intuitive Parking Assist System) 3. REMOVE ROCKER PANEL MOULDING COVER LH (w/o Intuitive Parking Assist System) ...

Installation

INSTALLATION PROCEDURE 1. INSTALL WIRELESS DOOR LOCK BUZZER (a) Connect the connector. (b) Attach the clamp to install the wireless door lock buzzer. 2. INSTALL FRONT FENDER LINER LH (w/ Intuitiv ...

Other materials about Toyota 4Runner:

Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. Vehicles without a smart key system Turn the engine switch off. Vehicles with a smart key system Turn the “ENGINE ...

Vsc Off Switch
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE DRIVE MONITOR SWITCH 2. REMOVE MAP LIGHT ASSEMBLY 3. REMOVE VSC OFF SWITCH (a) Disconnect the 2 connectors. ...