INSPECTION
PROCEDURE
1. INSPECT MAGNET CLUTCH ASSEMBLY
(a) Check the magnet clutch operation.
(1) Confirm that the magnet clutch hub and magnet clutch rotor lock when the positive (+) lead of the battery is connected to terminal 3 of the magnet clutch, and the negative (-) lead is connected to the ground wire.
If the operation is not as specified, replace the magnet clutch assembly.
Text in Illustration
*1 |
Magnet Clutch Rotor |
*2 |
Magnet Clutch Hub |
*3 |
Battery |
*a |
Component without harness connected (Magnet Clutch Assembly) |
(b) Measure the resistance between terminals 1 and 2.
Standard resistance:
65 to 125 Ω at 20°C (68°F)
If the result is not as specified, replace the cooler compressor assembly.
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed
for that code. For details of the code, refer to the "See page" below.
Transponder Key ECU Assembly
DTC Code
...
Using the AUX port
This port can be used to connect a portable audio device and listen to it
through the vehicle’s speakers.
Pull up the lid.
Open the cover and connect the portable audio device.
Press
or
.
Operating portable audio devices connected to the audio ...