INSPECTION
PROCEDURE
1. INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH
(a) Check the seat cushion heater.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
A-1 - B-1 |
Seat cushion heater temperature 20°C (68°F) |
3.4 to 4.2 Ω |
A-4 - B-2 |
||
A-1 - A-4 |
||
A-2 - A-3 |
8 to 12 kΩ |
If the result is not as specified, replace the front seat cushion heater assembly LH.
Text in Illustration
*1 |
Connector A |
*2 |
Connector B |
*a |
Component without harness connected (Front Seat Cushion Heater assembly LH) |
2. INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH
(a) Check the seat cushion heater.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
A-1 - B-1 |
Seat cushion heater temperature 20°C (68°F) |
3.4 to 4.2 Ω |
A-4 - B-2 |
||
A-1 - A-4 |
||
A-2 - A-3 |
8 to 12 kΩ |
If the result is not as specified, replace the front seat cushion heater assembly RH.
Text in Illustration
*1 |
Connector A |
*2 |
Connector B |
*a |
Component without harness connected (Front Seat Cushion Heater assembly RH) |
Diagnosis System
DIAGNOSIS SYSTEM
1. DESCRIPTION
(a) Air conditioning system data and Diagnostic Trouble Codes (DTCs) can be read
through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to
be malfunctioning, use the Techstream to check for malfunct ...
Driver Side Seat Belt Warning Light does not Operate
DESCRIPTION
When the ignition switch is turned to ON, the center airbag sensor transmits
front seat inner belt LH state signals to the combination meter through the CAN.
If the driver side seat belt is not fastened, the combination meter blinks the driver ...