INSPECTION
PROCEDURE
1. INSPECT SEAT HEATER SWITCH LH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
3 (SW) - 7 (RV) |
Switch off |
2.7 to 4.1 kΩ |
Switch on (Min.) |
||
Switch on (Max.) |
0.28 to 0.42 kΩ |
HINT:
As the dial is being turned, the resistance changes gradually.
If the result is not as specified, replace the seat heater switch.
Text in Illustration
*a |
Component without harness connected (Seat Heater Switch) |
(b) Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.
OK:
Measurement Condition |
Specified Condition |
---|---|
Battery positive (+) → 8 (ILL+) Battery negative (-) → 2 (ILL-) |
Illuminates |
If the result is not as specified, replace the seat heater switch.
(c) Apply battery voltage to the switch connector, and check that the seat heater switch indicator illuminates.
OK:
Measurement Condition |
Switch Condition |
Specified Condition |
---|---|---|
Battery positive (+) → 9 (IG) Battery negative (-) → 4 (E) |
Switch on |
Indicator illuminates |
If the result is not as specified, replace the seat heater switch.
2. INSPECT SEAT HEATER SWITCH RH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
2 (SW) - 5 (RV) |
Switch off |
2.7 to 4.1 kΩ |
Switch on (Min.) |
||
Switch on (Max.) |
0.28 to 0.42 kΩ |
HINT:
As the dial is being turned, the resistance changes gradually.
If the result is not as specified, replace the seat heater switch.
Text in Illustration
*a |
Component without harness connected (Seat Heater Switch) |
(b) Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.
OK:
Measurement Condition |
Specified Condition |
---|---|
Battery positive (+) → 6 (ILL+) Battery negative (-) → 1 (ILL-) |
Illuminates |
If the result is not as specified, replace the seat heater switch.
(c) Apply battery voltage to the switch connector, and check that the seat heater switch indicator illuminates.
OK:
Measurement Condition |
Switch Condition |
Specified Condition |
---|---|---|
Battery positive (+) → 7 (IG) Battery negative (-) → 3 (E) |
Switch on |
Indicator illuminates |
If the result is not as specified, replace the seat heater switch.
Initialization
INITIALIZATION
1. PROCEDURES NECESSARY WHEN CABLE IS DISCONNECTED/RECONNECTED TO BATTERY TERMINAL
Procedures Necessary when Cable is Disconnected/Reconnected to Battery Terminal
Necessary Procedure
Effect or Inoperative Function when N ...
Display does not Dim when Light Control Switch is Turned ON
PROCEDURE
1.
CHECK IMAGE QUALITY SETTING
(a) Turn the light control switch to the tail or head position.
(b) Check that the daytime screen setting on the display adjustment screen is
set to on.
Result
...