INSPECTION
PROCEDURE
1. INSPECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY
(a) Check the ELR. (1) When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is more than 45°, check that the belt locks. If the operation is not as specified, replace the seat belt assembly. |
|
(b) Check the fastening function of the child restraint system.
NOTICE:
The check should be performed with the outer belt installed.
(1) When the belt is pulled out fully, check that the belt automatically starts to retract.
(2) After the belt is fully retracted, check that the belt can be pulled out and retracted again.
If the operation is not as specified, replace the belt assembly.
Text in Illustration
*a |
Unlock |
*b |
Lock |
*c |
45° |
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when deciding whether a part
is faulty or not.
HINT:
Using the T ...
System Description
SYSTEM DESCRIPTION
1. SEAT BELT WARNING SYSTEM DESCRIPTION
If a seat belt is not fastened, this system flashes the seat belt warning light
or sounds the seat belt warning buzzer as a reminder.
(a) Driver side seat belt warning light:
The seat belt warnin ...