Toyota 4Runner: Inspection

Toyota 4Runner Service Manual / Vehicle Interior / Seat Belt / Rear No. 2 Seat Outer Belt Assembly / Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY

(a) Check the ELR.

(1) When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is more than 45°, check that the belt locks.

If the operation is not as specified, replace the seat belt assembly.

(b) Check the fastening function of the child restraint system.

NOTICE:

The check should be performed with the outer belt installed.

(1) When the belt is pulled out fully, check that the belt automatically starts to retract.

(2) After the belt is fully retracted, check that the belt can be pulled out and retracted again.

If the operation is not as specified, replace the belt assembly.

Text in Illustration

*a	Unlock
*b	Lock
*c	45°

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE REAR NO. 2 SEAT ASSEMBLY ...

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. A bolt without a torque specification is sh ...

Other materials about Toyota 4Runner:

How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the audio and visual system. *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...

Brake Actuator (Skid Control ECU) Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Brake Actuator (Skid Control ECU) Communication Stop Mode Either condition is met: "Skid Control (ABS/VSC/TRAC)" is not displa ...