Toyota 4Runner manuals

Toyota 4Runner: Inspection

INSPECTION

PROCEDURE

1. INSPECT NAVIGATION ANTENNA ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - Shield

Always

50 to 500 Ω

If the result is not as specified, replace the navigation antenna assembly.

Text in Illustration

*1

Shield

*a

Component without harness connected

(Navigation Antenna Assembly)


Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS sys ...

Installation
INSTALLATION PROCEDURE 1. INSTALL NAVIGATION ANTENNA ASSEMBLY (a) Install the antenna with the 2 screws. Torque: 2.5 N·m {25 kgf·cm, 22 in·lbf} (b) Attach the clamp. 2. INSTALL DEFROSTER NO ...

Other materials about Toyota 4Runner:

Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT SHOCK ABSORBER ASSEMBLY LH (a) Compress and extend the shock absorber rod and check that there is no abnormal resistance or unusual sound during operation. If there is any abnormality, replace the front shock absorbe ...

Installation
INSTALLATION PROCEDURE 1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (a) Connect the connector. NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness. ...

© 2016-2024 | www.to4runner.net

0.0108