Toyota 4Runner: Inspection

Toyota 4Runner Service Manual / Audio / Visual / Telematics / Park Assist / Monitoring / Ultrasonic Sensor(for Rear) / Inspection

INSPECTION

PROCEDURE

1. INSPECT NO. 1 ULTRASONIC SENSOR

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
1 (E) - 2 (S)	Always	20 to 40 kΩ

If the result is not as specified, replace the No. 1 ultrasonic sensor.

Removal

REMOVAL PROCEDURE 1. REMOVE JACK BOX HOLE COVER 2. REMOVE REAR QUARTER PANEL MUDGUARD LH 3. REMOVE REAR QUARTER PANEL MUDGUARD RH HINT: Use the same procedure as for the LH side. 4. REMOV ...

Installation

INSTALLATION PROCEDURE 1. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (a) Align the keyhole and protrusion as shown in the illustration. Text in Illustration *1 ...

Other materials about Toyota 4Runner:

Theft Deterrent System Presence Detection (B279C)
DESCRIPTION If an ECM that is incompatible with the engine immobiliser system is installed, the ECM stores this DTC. DTC Code DTC Detection Condition Trouble Area B279C An ECM for vehicles withou ...

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) When troubleshooting a vehicle with a diagnosis system, connect the Techstream to the DLC3 of the vehicle and read various data output from the steering lock actuator assembly (steering lock ECU). The steering lock ac ...