Toyota 4Runner: Inspection

Toyota 4Runner Service Manual / Brake / Brake System (other) / Brake Booster / Inspection

INSPECTION

PROCEDURE

1. INSPECT BRAKE VACUUM CHECK VALVE ASSEMBLY

(a) Check that there is ventilation from the booster to the engine and no ventilation from the engine to the booster.

Text in Illustration

*a	Ventilation
*b	No Ventilation

If the result is not as specified, replace the brake vacuum check valve assembly.

Removal

REMOVAL CAUTION / NOTICE / HINT NOTICE: Make sure to release the vacuum from the brake booster before removing the master cylinder from the brake booster. PROCEDURE 1. DRAIN BRAKE FLUID NOTICE ...

Installation

INSTALLATION CAUTION / NOTICE / HINT PROCEDURE 1. TEMPORARILY INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS (a) Install the lock nut and brake master cylinder push rod clevis to the brake booste ...

Other materials about Toyota 4Runner:

Hood Support
Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE HOOD SUPPORT ASSEMBLY LH NO ...

Lost Communication with ECM / PCM "A" (U0100,U0129,U0131,U0151)
DESCRIPTION The combination meter assembly communicates with the ECM via the CAN communication system (CAN No. 1 Bus). DTC Code. DTC Detection Condition Trouble Area U0100 IG voltage is 9.5 V or ...