INSPECTION
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD
HINT:
Adjust the booster push rod when the master cylinder is replaced with a new one. Adjustment is not necessary when the master cylinder is reinstalled and the booster is replaced with a new one.
(a) Apply chalk to the tip of the accessory tool.
HINT:
An accessory tool is included with a new brake master cylinder sub-assembly.
(b) Place the accessory tool on the brake booster assembly. Text in Illustration
|
|
(c) Measure the clearance between the brake booster push rod and accessory tool.
Standard clearance:
0 mm (0 in.)
Adjust the clearance in the following cases:
(d) If the clearance is not within the standard, adjust the length by holding the rod using SST and turning the tip of the rod using a 7 mm socket driver. SST: 09737-00020 NOTICE: Check the push rod clearance again after adjusting. |
|
No Answer-Back
DESCRIPTION
In some cases, the wireless door lock control functions are normal but the hazard
warning light and/or wireless door lock buzzer answer-back function(s) does not
operate. In such cases, hazard warning light and wireless door lock buzzer signal ...
Transfer Oil
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CHECK TRANSFER OIL
(a) Remove the filler plug and gasket.
(b) Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.)
f ...