Toyota 4Runner: Inspection

Toyota 4Runner Service Manual / Brake / Brake System (other) / Hydraulic Brake Booster / Inspection

INSPECTION

PROCEDURE

1. INSPECT BRAKE BOOSTER PUMP ASSEMBLY

(a) Apply battery voltage to the brake booster pump cables, and check the operation of the pump motor.

OK::

Measurement Condition	Specified Condition
Battery positive (+) voltage → Red cable terminal	Pump motor operates
Battery negative (-) voltage → Black cable terminal	Pump motor operates

Text in Illustration

*1	Red Cable
*2	Black Cable

If the result is not as specified, replace the brake booster pump assembly.

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE NO. 1 BRAKE ACTUATOR BRACKET (a) Using a 5 mm hexagon wrench, remove the bolt and No. 1 brake actuator bracket. ...

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL BRAKE BOOSTER PISTON SIB-ASSEMBLY (a) Apply a light coat of lithium soap base glycol grease to a new piston. (b ...

Other materials about Toyota 4Runner:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for both the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT FENDER MUDGUARD LH (w/o Intuitive Parking Assist System) 2. REMOVE FR ...

Front Airbag Sensor LH Malfunction (B1615/14)
DESCRIPTION The front airbag sensor LH consists of the diagnostic circuit and frontal deceleration sensor, etc. If the center airbag sensor receives signals from the frontal deceleration sensor, it determines whether the SRS should be activated. DTC B16 ...