Toyota 4Runner: Inspection

Toyota 4Runner Service Manual / Drivetrain / A750e Automatic Transmission / Transaxle / Park / Neutral Position Switch / Inspection

INSPECTION

PROCEDURE

1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
2 (RB) - 6 (PL) 4 (B) - 5 (L)	Shift lever in P	Below 1 Ω
2 (RB) - 1 (RL)	Shift lever in R	Below 1 Ω
2 (RB) - 9 (NL) 4 (B) - 5 (L)	Shift lever in N	Below 1 Ω
2 (RB) - 7 (DL)	Shift lever in D Shift lever in S, "+" or "-"	Below 1 Ω
2 (RB) - 6 (PL) 4 (B) - 5 (L)	Shift lever not in P	10 kΩ or higher
2 (RB) - 1 (RL)	Shift lever not in R	10 kΩ or higher
2 (RB) - 9 (NL) 4 (B) - 5 (L)	Shift lever not in N	10 kΩ or higher
2 (RB) - 7 (DL)	Shift lever not in D Shift lever not in S, "+" or "-"	10 kΩ or higher

Text in Illustration

*1	Component without harness connected (Park/Neutral Position Switch)

If the result is not as specified, replace the switch.

Removal

REMOVAL PROCEDURE 1. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY (a) Disconnect the switch connector. (b) Using a screwdriver, bend the tabs of the lock washer. ...

Adjustment

ADJUSTMENT PROCEDURE 1. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY (a) Loosen the bolt of the park/neutral position switch and move the shift lever to the N position. ...

Other materials about Toyota 4Runner:

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" ...

Rear No. 1 Seat Inner Belt Assembly(for 60/40 Split Double-folding Seat Type Rh Side)
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH (a) Pull the rear seat cushion band, release the lock and lift up the back of the seat cushion to rotate it forward. ...