INSPECTION
PROCEDURE
1. INSPECT TRANSMISSION CONTROL SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
3 (IG) - 7 (S) |
Shift lever in S, "+" or "-" |
Below 1 Ω |
3 (IG) - 7 (S) |
Shift lever not in S, "+" or "-" |
10 kΩ or higher |
*a |
Component without harness connected: (Transmission Control Switch) |
If the result is not as specified, replace the transmission floor shift.
Precaution
PRECAUTION
1. IGNITION SWITCH EXPRESSION
HINT:
The type of ignition switch used on this model differs according to the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ign ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL COOLER DRYER
(a) Using pliers, install the cooler dryer.
(b) Apply a sufficient amount of compressor oil to the contact surfaces
of a new O-ring and the cap.
Compressor oil:
ND-OIL 8 or equivalent
...