Toyota 4Runner: Inspection

Toyota 4Runner Service Manual / Drivetrain / Axle And Differential / Rear Axle Shaft / Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR AXLE SHAFT

(a) Using a dial indicator, measure the rear axle shaft runout and flange runout.

Maximum runout:

Shaft runout: 1.50 mm (0.0591 in.)

Flange runout: 0.05 mm (0.00197 in.)

If the rear axle shaft or flange is damaged or worn, or the runout is more than the maximum, replace the rear axle shaft.

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE ...

Reassembly

REASSEMBLY CAUTION / NOTICE / HINT NOTICE: Do not allow foreign matter, etc. to contact the rear axle hub and bearing assembly. PROCEDURE 1. INSTALL BRAKE DRUM OIL DEFLECTOR LH (a) Install a n ...

Other materials about Toyota 4Runner:

Removal
REMOVAL PROCEDURE 1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for VF2A) 3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY 4. REMOVE SEAT HEATER SWITCH (a) Disconnect the 2 connectors. ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE NO. 1 POWER OUTLET SOCKET ASSEMBLY 2. REMOVE NO. 1 POWER OUTLET SOCKET COVER 3. REMOVE REAR CONSOLE END PANEL (a) Detach the 4 clips and 4 claws to remove the rear console end panel. ...