Toyota 4Runner: Inspection

Toyota 4Runner Service Manual / Drivetrain / Drive Shaft / Propeller Shaft / Propeller Shaft Assembly(for 4wd) / Inspection

INSPECTION

PROCEDURE

1. INSPECT PROPELLER SHAFT ASSEMBLY

(a) Using a dial indicator, check the propeller shaft runout.

Maximum runout:

0.4 mm (0.0157 in.)

If the shaft runout is more than the maximum, replace the shaft.

2. INSPECT REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING

NOTICE:

Be careful not to grip the propeller shaft tube too tightly in a vise as this will cause deformation.

(a) Check the spider bearings for wear or damage.

If necessary, replace the spider bearing.

(b) Check the spider bearing axial play by turning the yoke while holding the shaft tightly.

Maximum bearing axial play:

0 mm (0 in.)

If the axial play is more than the maximum, replace the spider bearing.

Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE REAR PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING HINT: Use the same procedure for all rear propeller shaft universal joint spider bearing. (a) Place ...

INSTALLATION PROCEDURE 1. INSTALL PROPELLER SHAFT ASSEMBLY (a) Align the matchmarks on the propeller shaft flange and differential flange. (b) Install the propeller shaft assembly with the 4 washe ...

Other materials about Toyota 4Runner:

Installation
INSTALLATION PROCEDURE 1. INSTALL VANE PUMP ASSEMBLY (a) Install the vane pump with the 2 bolts. Torque: 43 N·m {438 kgf·cm, 32 ft·lbf} (b) Install the wire harness bracket with the bolt. Torque: 43 N·m {438 kgf·cm, 32 ft·lbf} 2. CONNECT NO. 1 ...

Registered Device cannot be Deleted
PROCEDURE 1. DELETE OPERATION (a) Check if a registered portable player can be deleted normally. OK: Registered portable player can be deleted normally. OK END NG PROCEED TO ...