INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See page ).
PROCEDURE
1. INSTALL POWER MANAGEMENT CONTROL ECU
(a) Attach the 2 claws to install the power management control ECU.
2. INSTALL ECU INTEGRATION BOX RH
(a) Install the ECU integration box RH with the 2 nuts and bolt.
(b) Attach the clamp.
(c) Connect all the connectors.
NOTICE:
3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY
4. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
5. INSTALL INSTRUMENT PANEL BOX DOOR COVER
6. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY
7. INSTALL LOWER INSTRUMENT COVER LH
8. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
9. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
HINT:
Use the same procedure described for the No. 1 instrument cluster finish panel garnish.
(a) Install the No. 2 instrument cluster finish panel garnish (See page ).
10. INSTALL COWL SIDE TRIM BOARD RH
(a) Attach the clip and claw to install the cowl side trim board.
(b) Install the clip.
11. INSTALL DOOR SCUFF PLATE ASSEMBLY RH
(a) Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate.
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
13. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light (See page ).
Auto Down Operation does not Fully Open Power Window (Catch Protection Function
is Activated)
DESCRIPTION
If any door glass or a power window regulator motor assembly does not operate
smoothly, the catch protection function may be triggered automatically, resulting
in the auto down operation being unable to fully open the power window.
CAUTION / ...
Capacity and distribution
Cargo capacity depends on the total weight of the occupants.
(Cargo capacity) = (Total load capacity) — (Total weight of occupants) Steps
for Determining Correct Load Limit-- (1)Locate the statement “The combined
weight of occupants and cargo should n ...