Toyota 4Runner: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See
page .gif)
).
PROCEDURE
1. INSTALL POWER STEERING ECU ASSEMBLY
(a) Attach the 2 claws to install the power steering ECU assembly.
2. INSTALL ECU INTEGRATION BOX RH
3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY
4. INSTALL INSTRUMENT LOWER PANEL SUB-ASSEMBLY
5. INSTALL INSTRUMENT PANEL BOX DOOR COVER
6. INSTALL INSTRUMENT NO. 2 LOWER PANEL AIRBAG ASSEMBLY
7. INSTALL INSTRUMENT LOWER COVER LH
8. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
9. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
10. INSTALL COWL SIDE TRIM BOARD RH
11. INSTALL DOOR SCUFF PLATE ASSEMBLY RH
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
13. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light (See page ).
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS sys ...
Other materials about Toyota 4Runner:
License Plate Light Assembly
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE OUTSIDE BACK DOOR GARNISH
(a) Remove the outside back door garnish (See page
).
2. REMOVE LICENSE PLATE LIGHT ASSEMBLY
(a) Remove the 4 screws and light.
...
Data List / Active Test
DATA LIST / ACTIVE TEST
1. ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and
other items to be operated without removing any parts. This non-intrusive functional
inspection can be very useful because inter ...
0.0267