Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Automatic Running Board Ecu / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page ).

PROCEDURE

1. INSTALL SIDE AUTO STEP CONTROLLER ECU ASSEMBLY

(a) Engage the guide and install the side auto step controller ECU assembly.

(b) Install the 2 bolts.

Torque:

8.5 N·m {87 kgf·cm, 75 in·lbf}

2. INSTALL DRIVER SIDE JUNCTION BLOCK ASSEMBLY

3. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

5. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

6. INSTALL COWL SIDE TRIM BOARD LH

7. INSTALL DOOR SCUFF PLATE ASSEMBLY LH

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

9. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (See page ).

Removal

REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS sys ...

Other materials about Toyota 4Runner:

Assist grips
An assist grip (type A) installed on the ceiling can be used to support your body while sitting on the seat. An assist grip (type B) installed on the pillar can be used when getting in or out of the vehicle and others. 1. Assist grip (type A) 2. Assi ...

Four-wheel drive system (part-time 4WD models)
Use the front-wheel drive control lever or switch to select the following transfer modes: Type A The four-wheel drive indicator comes on when H4, N or L4 mode is selected. 1. H2 (high speed position, two-wheel drive) Use this for normal driving on dry ...

Toyota 4Runner: Installation

Components

Removal

Other materials about Toyota 4Runner: