INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See page ).
PROCEDURE
1. INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY LH
(a) Install the front bumper bracket sub-assembly LH with the 2 bolts.
2. INSTALL FRONT BUMPER BRACKET SUB-ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
3. INSTALL FRONT BUMPER SIDE SUPPORT LH
(a) Attach the 2 claws to install the front bumper side support LH.
(b) Install the screw and bolt.
Torque:
Bolt :
5.4 N·m {55 kgf·cm, 49 in·lbf}
4. INSTALL FRONT BUMPER SIDE SUPPORT RH
HINT:
Use the same procedure as for the LH side.
5. INSTALL NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY LH
(a) Install the No. 2 front bumper extension sub-assembly LH with the 4 bolts.
Torque:
65 N·m {663 kgf·cm, 48 ft·lbf}
6. INSTALL NO. 2 FRONT BUMPER EXTENSION SUB-ASSEMBLY RH
HINT:
Use the same procedure as for the LH side.
7. INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
(a) Install the front bumper reinforcement sub-assembly with the 6 nuts and screw.
Torque:
Nut :
30 N·m {306 kgf·cm, 22 ft·lbf}
8. INSTALL FRONT BUMPER ENERGY ABSORBER
(a) Install the front bumper energy absorber.
9. INSTALL RADIATOR SIDE DEFLECTOR LH
10. INSTALL RADIATOR SIDE DEFLECTOR RH
11. INSTALL FRONT BUMPER LOWER COVER
(a) Install the front lower bumper cover with the 5 bolts and clip.
12. INSTALL UPPER CENTER FRONT BUMPER RETAINER
13. INSTALL FRONT BUMPER COVER
(a) Connect the 2 connectors.
(b) Attach the 14 claws to install the front bumper cover with radiator grille.
(c) Install the 3 bolts, 10 screws and 6 clips.
14. INSTALL UPPER RADIATOR SUPPORT SEAL
15. ADJUST FOG LIGHT AIMING
(See page )
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK POWER MANAGEMENT CONTROL ECU
(a) Disconnect the F80 power management control ECU connector.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
Terminal No. (Symbol)
Wirin ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
When installing the window frame moulding, heat the vehicle body and
window frame moulding using a ...