INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See page ).
PROCEDURE
1. INSTALL PINTLE HOOK SUPPORT TUBE SUB-ASSEMBLY (w/ Pintle Hook)
2. INSTALL REAR BUMPER UPPER RETAINER LH
3. INSTALL REAR BUMPER UPPER RETAINER RH
HINT:
Use the same procedure as for the LH side.
4. INSTALL REAR COMBINATION LIGHT LENS AND BODY LH
5. INSTALL REAR COMBINATION LIGHT LENS AND BODY RH
HINT:
Use the same procedure as for the LH side.
6. INSTALL REAR BUMPER SIDE SUPPORT LH
7. INSTALL REAR BUMPER SIDE SUPPORT RH
HINT:
Use the same procedure as for the LH side.
8. INSTALL REAR BUMPER BAR REINFORCEMENT LH
(a) Install the rear bumper bar reinforcement LH with the 2 bolts.
9. INSTALL REAR BUMPER BAR REINFORCEMENT RH
HINT:
Use the same procedure as for the LH side.
10. INSTALL REAR BUMPER ENERGY ABSORBER
11. INSTALL REAR BUMPER COVER
(a) Connect the connector.
(b) Attach the 18 claws to install the rear bumper cover.
(c) Install the 8 bolts and 4 screws.
12. INSTALL REAR QUARTER PANEL MUDGUARD LH
13. INSTALL REAR QUARTER PANEL MUDGUARD RH
HINT:
Use the same procedure as for the LH side.
14. INSTALL JACK BOX HOLE COVER
Mute Signal Circuit between Stereo Component Amplifier and Telematics Transceiver
DESCRIPTION
The DCM (telematics transceiver) sends a mute signal to the stereo component
amplifier assembly.
The stereo component amplifier assembly controls the volume according to the
mute signal from the DCM (telematics transceiver).
WIRING DIAGRAM
...
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT POWER SEAT SWITCH LH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Slide Switch
Tester Connection
Switch Condition
Specified Conditi ...