Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Exterior / Exterior Panels / Trim / Rear Door Belt Moulding / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL REAR DOOR BELT MOULDING LH

(a) Attach the 7 claws to install the rear door belt moulding.

2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH

3. INSTALL REAR DOOR QUARTER WINDOW GLASS LH

4. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH

5. INSTALL REAR DOOR GLASS RUN LH

6. INSTALL REAR DOOR SERVICE HOLE COVER LH

7. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH

8. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

9. INSTALL REAR DOOR INSIDE HANDLE BEZEL LH

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

11. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (See page ).

Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE ...

Rear Door Window Frame Moulding

...

Other materials about Toyota 4Runner:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK REAR FLOOR SIDE AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION) (a) Perform a diagnostic system check (See page ). 2. CHECK REAR FLOOR SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLO ...

Engine Speed Signal Error (Test Mode DTC) (C2194/94)
DESCRIPTION The tire pressure warning ECU receives an engine speed signal from the ECM. This DTC is stored upon entering test mode and cleared when an engine speed signal of 1000 rpm is detected for 3 seconds or more. This DTC is stored only in test mode. ...