INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
(a) Attach the claw to install the outer rear view mirror assembly LH.
|
(b) Install the 3 nuts in the order shown in the illustration. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} |
|
(c) Attach the clamp.
(d) Connect the connector.
2. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH
3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
4. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH
Reassembly
Outer Rear View Mirror CoverAll Power Windows do not Operate with Driver Side Door Key Cylinder or Wireless
Transmitter
DESCRIPTION
When a key switch is pushed: 1) the door control receiver receives the
key signal; 2) the door control receiver sends a signal to the certification
ECU; 3) the main body ECU (multiplex network body ECU) sends the operation
permi ...
Operation Check
OPERATION CHECK
1. CHECK INITIAL CHECK FUNCTION
(a) Check the initial check function for the buzzer.
(1) When the back sonar or clearance sonar switch assembly is turned on, check
that the following occurs: 1) after 0.2 seconds, the buzzer sounds for ap ...