INSTALLATION
PROCEDURE
1. INSTALL BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY
(a) Using a T25 "TORX" socket wrench, install the back power window regulator motor assembly with the 3 screws. HINT:
Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} |
|
2. INSTALL BACK DOOR POWER WINDOW REGULATOR SUB-ASSEMBLY
3. INSTALL OUTER BACK DOOR GLASS WEATHERSTRIP ASSEMBLY
4. INSTALL BACK DOOR GLASS
5. INSTALL BACK DOOR GLASS RUN
6. INSTALL NO. 1 BACK WINDOW WIPER MOTOR BRACKET
7. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY
8. INSTALL REAR WIPER ARM
9. INSTALL REAR SPOILER SUB-ASSEMBLY
10. INSTALL REAR NO. 1 SPOILER COVER
11. INSTALL BACK DOOR OUTSIDE MOULDING LH
12. INSTALL BACK DOOR OUTSIDE MOULDING RH
HINT:
Use the same procedure as described for the LH side.
13. INSTALL BACK DOOR SERVICE HOLE COVER LH
14. INSTALL BACK DOOR SERVICE HOLE COVER RH
15. INSTALL NO. 2 BACK DOOR SERVICE HOLE COVER
16. INSTALL MULTIPLEX NETWORK DOOR ECU
17. INSTALL REAR NO. 2 SPEAKER ASSEMBLY
18. INSTALL BACK DOOR TRIM PANEL ASSEMBLY
19. INSTALL ASSIST STRAP ASSEMBLY
20. INSTALL ASSIST STRAP HOLE COVER
21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
HINT:
If a trouble code is output during the DTC check, inspect the trouble areas listed
for that code. For details of the code, refer to the "See page" below.
Certification ECU
DTC Code
Detec ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK DRIVER SIDE JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK
BODY ECU)
(a) Remove the main body ECU (multiplex network body ECU) (See page
).
(b) Measure the voltage and resistance according to the value(s) in the ...