INSTALLATION
PROCEDURE
1. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
NOTICE:
The regulator arm must be below the intermediate position when installing the power window regulator motor.
(a) Using a T25 "TORX" socket wrench, install the power window regulator motor with the 3 screws. HINT:
Torque: 5.4 N·m {55 kgf·cm, 48 in·lbf} |
|
2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH
4. INSTALL FRONT DOOR SERVICE HOLE COVER LH
5. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY
6. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH
7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
8. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
9. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
11. INITIALIZE POWER WINDOW CONTROL SYSTEM
(a) Initialize the power window control system (See page ).
12. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light (See page ).
Navigation Receiver Assembly Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Navigation Receiver Assembly Communication Stop Mode
Either condition is met:
"Display and Navigation (AVN1)" is not displayed ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT GENERATOR WITH CLUTCH PULLEY
(a) Hold the center of the generator with clutch pulley and check that the outer
ring turns counterclockwise and does not turn clockwise.
Text in Illustration
Free
...