INSTALLATION
PROCEDURE
1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
NOTICE:
The regulator arm must be below the intermediate position when installing the rear power window regulator motor assembly.
(a) Using a T25 "TORX" socket wrench, install the power window regulator motor with the 3 screws. HINT:
Torque: 5.4 N·m {55 kgf·cm, 48 in·lbf} |
|
2. INSTALL REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
3. INSTALL REAR DOOR GLASS SUB-ASSEMBLY LH
4. INSTALL REAR DOOR QUARTER WINDOW GLASS LH
5. INSTALL REAR DOOR WINDOW REAR LOWER FRAME SUB-ASSEMBLY LH
6. INSTALL REAR DOOR GLASS RUN LH
7. INSTALL REAR DOOR SERVICE HOLE COVER LH
8. INSTALL REAR SPEAKER ASSEMBLY
9. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP LH
10. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
11. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH
12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
13. INITIALIZE POWER WINDOW CONTROL SYSTEM
(a) Initialize the power window control system (See page ).
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / (desired system) / DTC.
(e) Read the DTCs.
2. CLEAR DTC
(a) Connect ...
Horn
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT HIGH PITCHED HORN ASSEMBLY
(a) Apply battery voltage and check the operation of the horn according to the
table below.
OK:
Measurement Condition
...