INSTALLATION
PROCEDURE
1. INSTALL REAR WIPER MOTOR AND BRACKET ASSEMBLY
(a) Attach the 2 guides and temporally install the rear wiper motor and bracket assembly with the 3 bolts. |
|
(b) Tighten the 3 bolts.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
(c) Connect the connector.
2. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY
(a) Clean the wiper arm serrations. Text in Illustration
|
|
(b) Clean the wiper pivot serrations with a wire brush. Text in Illustration
|
|
(c) Operate the rear wiper and stop the rear wiper motor at the automatic stop position.
HINT:
The wiper motor does not operate if the back door and back door glass are not closed.
(d) With the rear wiper blade and linear wiper step in the positions shown in the illustration, install the rear wiper blade assembly with the nut. Torque: 5.5 N·m {56 kgf·cm, 49 in·lbf} Text in Illustration
HINT: Hold the arm hinge down by hand while tightening the nut. |
|
(e) Place the rear wiper blade assembly in the automatic stop position. Text in Illustration
|
|
3. INSTALL REAR SPOILER SUB-ASSEMBLY
4. INSTALL REAR NO. 1 SPOILER COVER
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
Disc cannot be Inserted or is Ejected Right After Insertion
CAUTION / NOTICE / HINT
NOTICE:
After replacing the navigation receiver assembly of vehicles subscribed to pay-type
satellite radio broadcasts, XM radio ID registration is necessary.
PROCEDURE
1.
CHECK IF A PROPER DISC IS INSERTED
...
Terminals Of Ecu
TERMINALS OF ECU
1. RADIO AND DISPLAY RECEIVER ASSEMBLY
Terminal No. (Symbols)
Wiring Color
Terminal Description
Condition
Specification
G48-1 (FR+) - G48-7 (GND)
P - BR
...