INSTALLATION
PROCEDURE
1. INSTALL LEVEL WARNING SWITCH ASSEMBLY
(a) Install the level warning switch assembly to the packing of the washer jar.
2. INSTALL WASHER JAR PROTECTOR
(a) Attach the 3 claws to install the washer jar protector.
3. INSTALL WASHER JAR
4. INSTALL WASHER INLET SUB-ASSEMBLY
5. FILL WINDSHIELD WASHER FLUID
6. INSTALL FRONT FENDER LINER RH
(See page )
7. INSTALL FRONT BUMPER COVER (w/ Intuitive Parking Assist System)
(See page )
8. INSTALL FRONT BUMPER COVER (w/o Intuitive Parking Assist System)
(See page )
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
10. ADJUST FOG LIGHT AIMING
(See page )
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(a) Disconnect the h1 multiplex network master switch connector.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the values on the wi ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT PROPELLER SHAFT ASSEMBLY
(a) Align the matchmarks on the yoke and differential flange.
(b) Install the propeller shaft assembly with the 4 washers, 4 bolts and 4 nuts.
Torque:
88 N·m {899 kgf·cm, 65 ft·lbf}
(c ...