Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Interior / Door Lock / Door Control Switch / Installation

INSTALLATION

PROCEDURE

1. INSTALL DOOR CONTROL SWITCH ASSEMBLY

(a) Attach the 2 claws to install the door control switch assembly.

(b) Connect the door control switch connector.

2. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP RH

(a) Install the front door inner glass weatherstrip RH.

3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY RH

(a) Connect the front door lock remote control cable assembly and front door inside locking cable assembly.

(b) Connect the connector.

(c) Attach the front door trim board sub-assembly to the 4 claws of the front door inner glass as shown in the illustration.

(d) Attach the 11 clips to install the front door trim board sub-assembly RH.

(e) Install the 3 screws.

(f) Attach the 4 claws to install the 2 door armrest caps.

4. INSTALL DOOR NO. 2 INSIDE HANDLE BEZEL RH

(a) Attach the 3 claws to install the No.2 inside handle bezel RH.

5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH RH

(a) Attach the 2 clips to install the front door lower frame bracket garnish RH.

Removal

REMOVAL PROCEDURE 1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH RH (a) Detach the 2 clips and remove the front door lower frame bracket garnish RH. ...

Door Control Transmitter(w/ Smart Key System)

Components COMPONENTS ILLUSTRATION Removal REMOVAL CAUTION / NOTICE / HINT NOTICE: Take extra care when handling these precision electronic components. PROCEDURE 1. REMOVE TRANSMITTER B ...

Other materials about Toyota 4Runner:

Speed Sensor Circuit Malfunction (C1883/83)
DESCRIPTION The stabilizer control ECU receives the speed signal from the skid control ECU via CAN communication. DTC Code DTC Detection Condition Trouble Area C1883/83 The stabilizer control ECU ...

Washer Nozzle(for Rear Side)
Components COMPONENTS ILLUSTRATION On-vehicle Inspection ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: The washer fluid does not spray if the back door and back door glass are not closed. PROCEDURE 1. INSPECT REAR WASHER NOZZLE (a) With ...