Toyota 4Runner: Installation
INSTALLATION
PROCEDURE
1. INSTALL WIRELESS DOOR LOCK BUZZER
(a) Connect the connector.
(b) Attach the clamp to install the wireless door lock buzzer.
2. INSTALL FRONT FENDER LINER LH (w/ Intuitive Parking Assist System)
(a) Install the front fender liner LH with the 13 new grommets, clip and 7 screws.
3. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH (w/ Intuitive Parking Assist System)
.gif)
4. INSTALL ROCKER PANEL MOULDING LH (w/ Intuitive Parking Assist System)
5. INSTALL FRONT FENDER MUDGUARD LH (w/ Intuitive Parking Assist System)
6. INSTALL FRONT FENDER LINER LH (w/o Intuitive Parking Assist System)
(a) Install the front fender liner LH with the 13 new grommets and 5 screws.
7. INSTALL FRONT FENDER MOULDING SUB-ASSEMBLY LH (w/o Intuitive Parking Assist System)
8. INSTALL ROCKER PANEL MOULDING COVER LH (w/o Intuitive Parking Assist System)
9. INSTALL FRONT FENDER MUDGUARD LH (w/o Intuitive Parking Assist System)
10. INSTALL FRONT WHEEL
Torque:
for aluminum wheel :
103 N·m {1050 kgf·cm, 76 ft·lbf}
for steel wheel :
112 N·m {1142 kgf·cm, 83 ft·lbf}
Inspection
INSPECTION
PROCEDURE
1. INSPECT WIRELESS DOOR LOCK BUZZER
(a) Measure the resistance according to the value(s) in the table below.
HINT:
The buzzer activation circuit is built into ...
Other materials about Toyota 4Runner:
Operation Check
OPERATION CHECK
1. INSPECT DRIVER SIDE SEAT BELT WARNING LIGHT
(a) Turn the ignition switch to ON.
(b) When the driver seat belt is not fastened, check that the seat belt warning
light on the combination meter assembly blinks for 6 seconds. After 1.8 seco ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL HOOD LOCK ASSEMBLY
(a) Apply MP grease to the sliding areas of the hood lock assembly.
(b) Connect the hood lock control cable assembly.
(c) Connect the connector.
(d) Install the hood lock assembly with the 3 ...
0.0251