Toyota 4Runner manuals

Toyota 4Runner: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

A bolt without a torque specification is shown in the standard bolt chart (See page ).


PROCEDURE

1. INSTALL AIR CONDITIONER AMPLIFIER ASSEMBLY

(a) Attach the 2 claws to install the air conditioning amplifier assembly.

2. INSTALL ECU INTEGRATION BOX RH

(a) Install the ECU integration box RH with the 2 nuts and bolt.

(b) Attach the clamp and connect the connectors.

NOTICE:

  • Do not twist the connectors of ECU when connecting them.
  • Do not apply more force than necessary to the connectors. If more than 98 N (10 kgf, 22 lbf) of force is applied to a connector, the connector or connector holder may be damaged.

3. INSTALL NO. 2 AIR DUCT SUB-ASSEMBLY


4. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY


5. INSTALL INSTRUMENT PANEL BOX DOOR COVER


6. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY


7. INSTALL LOWER INSTRUMENT COVER LH


8. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


9. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

(a) Attach the 5 clips to install the No. 2 instrument cluster finish panel garnish.

10. INSTALL COWL SIDE TRIM BOARD RH

(a) Attach the clip and claw to install the cowl side trim board.

11. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

(a) Attach the 4 clips, 10 claws and 2 guides to install the door scuff plate.

(b) Install the clip.

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).


13. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (See page ).


Components
COMPONENTS ILLUSTRATION ...

Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS sys ...

Other materials about Toyota 4Runner:

Automatic Disconnecting Differential Actuator
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL AUTOMATIC DISCONNECTING DIFFERENTIAL ACTUATOR (a) Remove any old FIPG material. NOTICE: Be careful not to drop oil on the contact surfaces of the actuator and clut ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE FRONT AXLE WITH ABS ROTOR BEARING ASSEMBLY LH (a) Gently fix the front axle hub in a vise between aluminum plates. (b) Using SST, remove the bearing. SST: 09710-300 ...

© 2016-2024 | www.to4runner.net

0.0065