INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
PROCEDURE
1. INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY LH
(a) Set the front seat cushion heater assembly LH in place with the name stamp side facing the seat cushion cover. Text in Illustration
|
|
(b) Install the front seat cushion heater assembly LH with new 22 tack pins.
(c) Connect the wire harness to the separate type front seat cushion cover. |
|
2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER
(a) Using hog ring pliers, install the separate type front seat cushion cover to the separate type front seat cushion pad with 15 new hog rings.
Text in Illustration
*1 |
Hog Ring Pliers |
NOTICE:
3. INSTALL SEAT CUSHION COVER WITH PAD
(a) Attach the 7 hooks to install the seat cushion cover with pad.
(b) Connect the seat heater connector and attach the 3 wire harness clamps.
(c) Attach the 2 hooks.
(d) Attach the fastening tape to connect the airbag wire harness.
(e) Connect the seat heater connector and attach the wire harness clamp.
(f) w/o Climate Control Seat System:
Install the rubber band to the separate type front seat cushion spring assembly.
4. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH
5. INSTALL FRONT SEAT INNER CUSHION SHIELD LH (for Driver Side)
6. INSTALL FRONT SEAT INNER CUSHION SHIELD RH (for Front Passenger Side)
7. INSTALL FRONT SEAT CUSHION SHIELD LH
8. INSTALL FRONT SEATBACK BOARD CLIP (w/ Climate Control Seat System)
Click here
9. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Climate Control Seat System)
10. INSTALL FRONT SEAT ASSEMBLY
(See page )
Precaution
PRECAUTION
1. PRECAUTIONS WHEN WORKING ON ELECTRIC STEERING LOCK
(a) After replacing the steering lock actuator assembly (steering lock ECU),
perform key ID code registration.
(b) After replacing the steering lock actuator assembly (steering lock ECU),
...
Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
NOTICE:
When installing parts, coat the parts indicated by arrows with power steering
fluid (See page ).
PROCEDURE
1. INSTALL VANE PUMP HOUSING OIL SEAL
(a) Coat the lip of a new vane pump housing oil seal with MP gr ...