INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
PROCEDURE
1. INSTALL REAR NO. 2 SEAT ASSEMBLY LH
(a) Place the rear No. 2 seat assembly in the cabin.
NOTICE:
Be careful not to damage the vehicle body.
HINT:
If installing the seat on the RH side with the LH side installed, install it with the rear seat leg cover LH raised.
(b) Temporarily install the 4 bolts.
(c) Tighten the 4 bolts.
Torque:
37 N·m {377 kgf·cm, 27 ft·lbf}
(d) Attach the 6 claws and 2 guides to close the 2 covers. Text in Illustration
|
|
2. INSTALL NO. 1 DECK BOARD BRACKET LH
(a) Install the bracket with the 2 bolts.
3. INSTALL DECK BOARD BRACKET REINFORCEMENT
(a) Attach the 2 hooks to install the reinforcement.
(b) Install the 2 bolts.
4. INSTALL REAR NO. 3 FLOOR BOARD
(a) Attach the 2 guides and 4 claws. Text in Illustration
|
|
(b) Attach the clip to install the board.
5. INSTALL REAR NO. 4 FLOOR BOARD
(a) Attach the 2 guides and 4 claws. Text in Illustration
|
|
(b) Attach the clip to install the board.
6. INSTALL REAR FLOOR MAT SUPPORT PLATE
(a) Attach the 5 clips and 2 guides.
(b) Attach the 4 claws to install the plate.
(c) Install the 3 bolts.
7. INSTALL DECK BOARD ASSEMBLY
(a) Attach the 4 clips to install the board.
(b) Install the 2 bolts.
(c) Attach the 2 claws to close the cover. HINT: Use the same procedure to close the cover on the other side. |
|
System Description
SYSTEM DESCRIPTION
1. WINDOW DEFOGGER SYSTEM DESCRIPTION
The thin heater wires of the defogger system are attached to the rear window
and defog the rear window surface quickly. The system only operates when the back
door power window is closed. The indic ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR WIPER MOTOR AND BRACKET ASSEMBLY
(a) Check the wiper intermittent operation.
(1) Connect the positive (+) lead of the battery to terminal 5 (L) and
the negative (-) lead to terminal 4 (E), and check tha ...