INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See page ).
PROCEDURE
1. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH
(a) Install the inner belt and connect the center outer belt with the bolt.
Torque:
42 N·m {428 kgf·cm, 31 ft·lbf}
NOTICE:
Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding part of the front seat adjuster.
Text in Illustration
*a |
Protruding Part |
2. INSTALL SEAT CUSHION COVER WITH PAD
3. INSTALL REAR SEATBACK LOCK STRIKER COVER LH
4. INSTALL REAR SEAT CUSHION MOULDING LH
5. INSTALL CENTER SEAT HINGE COVER RH
6. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH
7. INSTALL REAR SEAT UPPER RECLINING COVER LH
8. INSTALL REAR SEAT ASSEMBLY LH
(a) Install the rear seat assembly LH (See page ).
Installation
INSTALLATION
PROCEDURE
1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY
(a) Install the headlight dimmer switch to the steering column, making
sure that the stopper protrusions and cutout parts align.
...
Lumbar Switch
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT LUMBAR SWITCH ASSEMBLY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Switch ...