INSTALLATION
PROCEDURE
1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
(a) Connect the connector. NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness. |
|
(b) Install the airbag assembly with the 4 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
3. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
4. INSTALL COWL SIDE TRIM BOARD LH
5. INSTALL DOOR SCUFF PLATE ASSEMBLY LH
6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
7. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light (See page ).
All Doors LOCK/UNLOCK Functions do not Operate Via Master Switch, Driver Side
Door Key Cylinder
DESCRIPTION
The main body ECU (multiplex network body ECU) receives switch signals from the
multiplex network master switch, and key-linked switch signals from the front door
lock. The main body ECU (multiplex network body ECU) activates the door lock mot ...
Room Oscillator does not Recognize Key
DESCRIPTION
If the room oscillator does not recognize the key, one of the following may be
the cause: 1) communication between the indoor No. 1 electrical key antenna (front
floor) and electrical key transmitter cannot be performed; 2) communication betwe ...