Toyota 4Runner: Installation
INSTALLATION
PROCEDURE
1. INSTALL OCCUPANT CLASSIFICATION ECU
|
(a) Attach the claw to install the occupant classification ECU. NOTICE: If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant classification ECU with a new one. |
|
(b) Connect the 2 connectors.
NOTICE:
When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
2. INSTALL FRONT SEAT ASSEMBLY RH
HINT:
Refer to the procedure from Install Front Seat Assembly (See page
.gif)
).
3. ZERO POINT CALIBRATION AND SENSITIVITY CHECK
(a) Perform zero point calibration and the sensitivity check (See page
).
4. PERFORM DIAGNOSTIC SYSTEM CHECK
(a) Perform a diagnostic system check (See page
).
5. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light (See page ).
On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to follow the correct removal and installation procedures for the occupant
classification ECU.
PROCEDURE
1. CHECK OCCUPANT CLASSIF ...
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing (See page
).
NOTICE:
When removing the front seat assembly RH, perform zero point calibr ...
Other materials about Toyota 4Runner:
If the vehicle battery is discharged
The following procedures may be used to start the engine if the vehicle's
battery is discharged.
You can also call your Toyota dealer or a qualified repair shop.
If you have a set of jumper (or booster) cables and a second vehicle with a
12-volt batt ...
Party mode switch
Party mode switch You can switch the sounds quality types by pressing the
switch.
1. Base mode
2. Party mode
In party mode, the sound volume from the speakers on the back door is bigger
than in base mode.
(The output from the speakers on the rear do ...
0.0078