INSTALLATION
PROCEDURE
1. INSTALL REAR FLOOR SIDE AIRBAG SENSOR
(a) Turn the ignition switch off.
(b) Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
(c) Install the rear floor airbag sensor with the bolt.
Torque:
9.0 N·m {92 kgf·cm, 80 in·lbf}
NOTICE:
(d) Check that the rear floor airbag sensor is not loose.
(e) Connect the connector.
2. INSTALL REAR FLOOR SIDE AIRBAG SENSOR COVER
(a) Attach the clip and claw to install the cover.
(b) Return the floor carpet to its original position.
3. INSTALL REAR DOOR SCUFF PLATE LH
4. INSTALL REAR DOOR SCUFF PLATE RH
5. INSTALL QUARTER SCUFF PLATE LH (w/ Rear No. 2 Seat)
6. INSTALL QUARTER SCUFF PLATE RH (w/ Rear No. 2 Seat)
7. INSTALL REAR NO. 1 FLOOR STEP COVER (w/ Rear No. 2 Seat)
8. INSTALL REAR NO. 1 SEAT ASSEMBLY
(a) for 60/40 Split Double-folding Seat Type LH Side
(1) Install the rear No. 1 seat assembly (See page ).
(b) for 60/40 Split Double-folding Seat Type RH Side
(1) Install the rear No. 1 seat assembly (See page ).
(c) for 60/40 Split Slide Walk-in Seat Type LH Side
(1) Install the rear No. 1 seat assembly (See page ).
(d) for 60/40 Split Slide Walk-in Seat Type RH Side
(1) Install the rear No. 1 seat assembly (See page ).
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
10. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light (See page ).
Steering Angle Sensor Zero Point Malfunction (C1290)
DESCRIPTION
The skid control ECU acquires steering angle sensor zero point every time the
ignition switch is turned to ON and the vehicle is driven at 40 km/h (25 mph) or
more for approximately 10 seconds. The ECU also stores the previous zero point.
If ...
Seat belts
Make sure that all occupants are wearing their seat belts before driving
the vehicle.
Correct use of the seat belts
• Extend the shoulder belt so that it comes fully over the shoulder, but does
not come into contact with the neck or slide off the sho ...