Toyota 4Runner: Installation

Toyota 4Runner Service Manual / Vehicle Interior / Supplemental Restraint Systems / Side Airbag Sensor / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY LH

(a) Turn the ignition switch off.

(b) Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

Torque:

9.0 N·m {92 kgf·cm, 80 in·lbf}

NOTICE:

If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Check that the side airbag sensor is not loose.

(e) Connect the connector.

2. INSTALL FRONT DOOR GLASS WEATHERSTRIP INNER LH

3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

4. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

7. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (See page ).

On-vehicle Inspection

ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. CHECK SIDE AIRBAG ...

Other materials about Toyota 4Runner:

Ptc Heater Assembly
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE AIR CONDITIONING UNIT (a) Remove the air conditioning unit (See page ). 2. REMOVE QUICK HEATER ASSEMBLY (a) Detach the 2 clamps. ...

Terminals Of Ecu
TERMINALS OF ECU 1. REAR TELEVISION CAMERA ASSEMBLY (a) Disconnect the Y2 rear television camera assembly connector. (b) Measure the voltage according to the value(s) in the table below. Terminal No. (Symbol) Wiring Color ...