INSTALLATION
PROCEDURE
1. INSTALL STEERING PAD
(a) Support the steering pad with one hand. |
|
(b) Connect the 2 connectors to the steering pad.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
(c) Connect the horn connector.
(d) Confirm that the groove along the circumference of the "TORX" screw is attached to the screw case and place the steering pad onto the steering wheel.
(e) Using a T30 "TORX" socket wrench, tighten the 2 screws.
Torque:
8.8 N·m {90 kgf·cm, 78 in·lbf}
2. INSTALL LOWER NO. 3 STEERING WHEEL COVER
(a) Attach the 2 claws to install the cover.
3. INSTALL LOWER NO. 2 STEERING WHEEL COVER
(a) Attach the 2 claws to install the cover. Text in Illustration
|
|
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
5. INSPECT STEERING PAD
(a) With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.
(b) Make sure that the horn sounds.
If the horn does not sound, inspect the horn system.
6. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light (See page ).
Clearance Sonar Main Switch Circuit
DESCRIPTION
When the back sonar or clearance sonar switch assembly turns on, the on signal
is input into the clearance warning ECU assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before pe ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL BRAKE BOOSTER PISTON SIB-ASSEMBLY
(a) Apply a light coat of lithium soap base glycol grease to a new piston.
(b) Install the piston.
NOTICE:
When installing, be careful ...