INSTALLATION
PROCEDURE
1. INSTALL STEREO COMPONENT TUNER ASSEMBLY
(a) Connect the 6 connectors to the radio and display receiver assembly or navigation receiver assembly and stereo component tuner assembly.
HINT:
Connect the connectors with white tape to the radio and display receiver assembly or navigation receiver assembly.
2. INSTALL NO. 2 RADIO BRACKET
3. INSTALL NO. 1 RADIO BRACKET
4. INSTALL HAZARD SWITCH WIRE
5. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)
6. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH BRACKETS (for Navigation Receiver Type)
7. INSTALL HEATER CONTROL ASSEMBLY
8. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
9. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
11. CHECK SRS WARNING LIGHT
(See page )
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT INDICATOR LIGHT
(a) Check that the KDSS indicator light comes on for 2 seconds when the ignition
switch is turned to ON.
If the indicator check result is not normal, proceed to troubleshooting for the
Problem ...
Air conditioning filter
The air conditioning filter must be changed regularly to maintain air
conditioning efficiency.
Removal method
Turn the engine switch (vehicles
without a smart key system) or “ENGINE START STOP” switch (vehicles with a smart
key system) off.
Ope ...