Toyota 4Runner: Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 STEREO JACK ADAPTER ASSEMBLY
(a) Attach the 2 claws to install the No. 1 stereo jack adapter assembly.
2. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Climate Control Seat System)
.gif)
3. INSTALL LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/ Climate Control Seat System)
4. INSTALL NO. 2 CONSOLE BOX RETAINER
5. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY
6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for VF2A)
7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
8. INSTALL HEATER CONTROL ASSEMBLY
9. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
10. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable
is reconnected (See page ).
12. CHECK SRS WARNING LIGHT
(See page )
Removal
REMOVAL
PROCEDURE
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-)
battery terminal to disable the SRS sys ...
Window Glass Antenna Wire
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT WINDOW GLASS ANTENNA WIRE
(a) Check for continuity of the window glass antenna wire.
Text in Illustration
...
Other materials about Toyota 4Runner:
Open or Short in Rear Speed Sensor RH Circuit (C1407,C1408)
DESCRIPTION
Refer to DTCs C1401 and C1402 (See page ).
DTC Code
DTC Detection Condition
Trouble Area
C1407
C1408
Either condition is met:
An open in the speed sensor signal circui ...
Door Mirror Foot Light Circuit
DESCRIPTION
The main body ECU controls the door mirror foot light.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Inspect the fuses for circuits related to this system before performing
the following procedure.
PROCEDURE
1 ...
0.0256