INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL FRONT DISC
(a) Align the matchmarks and install the front disc.
HINT:
When replacing the disc with a new one, select the installation position where the disc has the smallest runout.
2. INSTALL DISC BRAKE CYLINDER ASSEMBLY LH
(a) Install the disc brake cylinder assembly with the 2 bolts.
Torque:
185 N·m {1887 kgf·cm, 137 ft·lbf}
(b) Using a union nut wrench, connect the brake tube to the disc brake cylinder assembly.
Torque:
15 N·m {155 kgf·cm, 11 ft·lbf}
NOTICE:
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page ).
3. INSTALL FRONT NO. 1 ANTI-SQUEAL SHIM
NOTICE:
If necessary, replace the anti-squeal shim when replacing the brake pad.
(a) Install the front No. 1 anti-squeal shims to the front disc brake pads.
NOTICE:
There should be no oil or grease on the friction surfaces of the front disc brake pads and the front disc.
4. INSTALL FRONT DISC BRAKE PAD
(a) Install the 2 front disc brake pads to the disc brake cylinder.
(b) Install the anti-rattle spring between the 2 front disc brake pads.
NOTICE:
The anti-rattle spring can be reused if it has sufficient rebound; no deformation, cracks or wear; and has had all rust, dirt and foreign matter cleaned off.
(c) Install the 2 hole pins.
(d) Install the pin hold clip.
NOTICE:
The pin hold clip can be reused if has sufficient rebound; no deformation or wear; and has had all rust, dirt and foreign matter cleaned off.
5. BLEED BRAKE LINE
6. INSTALL FRONT WHEEL
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart (See
page ).
PROCEDURE
1. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
(a) Attach the 2 guides to install the instrument panel sub-assembly.
...
Air Conditioning Control Panel does not Operate
DESCRIPTION
When a switch of the air conditioning control assembly is operated, the air conditioning
control assembly uses LIN communication to communicate with the air conditioning
amplifier. If a switch of the air conditioning control assembly does not ...