Toyota 4Runner: Installation
INSTALLATION
CAUTION / NOTICE / HINT
PROCEDURE
1. TEMPORARILY INSTALL BRAKE MASTER CYLINDER PUSH ROD CLEVIS
(a) Install the lock nut and brake master cylinder push rod clevis to the brake booster assembly.
HINT:
Tighten the lock nut after adjusting the brake pedal height.
2. INSTALL BRAKE BOOSTER GASKET
(a) Install a new brake booster gasket to the brake booster assembly.
3. INSTALL BRAKE BOOSTER ASSEMBLY
(a) Install the brake booster assembly to the body with the 4 nuts.
Torque:
14 N·m {145 kgf·cm, 10 ft·lbf}
NOTICE:
Do not damage the brake lines.
4. INSTALL CHECK VALVE GROMMET
(a) Install a check valve grommet to the brake booster assembly.
5. INSTALL BRAKE VACUUM CHECK VALVE ASSEMBLY
(a) Install the vacuum check valve assembly to the brake booster assembly.
6. CONNECT VACUUM HOSE
(a) Connect the vacuum hose with the clip.
7. INSTALL PUSH ROD PIN
.gif)
8. INSTALL BRAKE PEDAL RETURN SPRING
9. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
(a) Install the brake master cylinder sub-assembly (See page
).
10. BLEED BRAKE SYSTEM
11. CHECK AND ADJUST BRAKE PEDAL
(a) Check and adjust the brake pedal (See page
).
Inspection
INSPECTION
PROCEDURE
1. INSPECT BRAKE VACUUM CHECK VALVE ASSEMBLY
(a) Check that there is ventilation from the booster to the engine and
no ventilation from the engine to the booster ...
Other materials about Toyota 4Runner:
Unable To Connect To Call Center
DESCRIPTION
This may occur when the intensity of the telephone radio frequency was very weak,
PRL updates are required or the Safety Connect system has a malfunction, and a DTC
is stored.
PROCEDURE
1.
CHECK COMMUNICATION SERVICE C ...
Using the interior lights
Interior lights list
1. Rear interior light
2. Front interior light/front personal lights
3. Shift lever light (when the engine switch is in the “ACC” or “ON” position
[without a smart key system] or “ENGINE START STOP” switch is in ACCESS ...
0.0129