INSTALLATION
PROCEDURE
1. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY
(a) Attach the claws of the No. 2 parking brake cable.
(b) Install the No. 2 parking brake cable assembly to the parking brake equalizer with the clip.
(c) Install the No. 2 parking brake cable assembly with the 5 bolts.
Torque:
13 N·m {127 kgf·cm, 9 ft·lbf}
(d) Install the No. 1 parking brake cable heat insulator.
Torque:
13 N·m {127 kgf·cm, 9 ft·lbf}
(e) Install the No. 2 parking brake cable assembly to the backing plate with the 2 bolts.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
2. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
(a) Attach the claws of the No. 3 parking brake cable.
(b) Install the No. 3 parking brake cable assembly to the parking brake equalizer with the clip.
(c) Install the No. 3 parking brake cable assembly with the 4 bolts.
Torque:
13 N·m {127 kgf·cm, 9 ft·lbf}
(d) Install the No. 3 parking brake cable assembly to the backing plate with the 2 bolts.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
3. INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY WITH PARKING BRAKE SHOE LEVER
HINT:
Refer to the procedures from "Install No. 2 Parking Brake Shoe Assembly with Parking Brake Shoe Lever" (See page ).
4. INSTALL FUEL TANK SUB-ASSEMBLY
(a) Install the fuel tank sub-assembly (See page ).
5. ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL
6. INSTALL REAR CONSOLE BOX ASSEMBLY
(a) Install the rear console box assembly (See page ).
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).
Outside Vehicle
General Maintenance
GENERAL MAINTENANCE
CAUTION / NOTICE / HINT
Performing the following maintenance checks on the vehicle is the owner's
responsibility. The owner may perform the maintenance or take the vehicle
to a service center. Che ...
Mudguard
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the RH and LH sides.
The procedure listed below is for LH side.
PROCEDURE
1. REMOVE FRONT FENDER M ...