Toyota 4Runner manuals

Toyota 4Runner: Installation

INSTALLATION

PROCEDURE

1. INSTALL PARKING PEDAL PAD

(a) Install the parking pedal pad.

2. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY

(a) Temporarily install the No. 1 parking brake cable assembly with the adjusting nut and lock nut.

(b) Install the No. 1 parking brake cable assembly with the 4 nuts and 3 bolts.


Torque:

for nut A :

6.0 N·m {61 kgf·cm, 53 in·lbf}

for bolt B :

13 N·m {127 kgf·cm, 9 ft·lbf}

(c) Pass the No. 1 parking brake cable through the parking brake pedal.


(d) Install the clip.

(e) Bend the parking brake pedal claw.

(f) Temporarily install the adjusting nut and lock nut to the No. 1 parking brake cable.

3. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY

(a) Install the parking brake control pedal assembly with the 3 nuts.

Torque:

13 N·m {127 kgf·cm, 9 ft·lbf}

(b) Connect the parking brake switch connector.

4. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

(a) Transmission type A750F:

Install the transmission floor shift assembly (See page ).


(b) Transmission type A750E:

Install the transmission floor shift assembly (See page ).


5. INSTALL AIRBAG SENSOR ASSEMBLY


6. INSTALL YAW RATE AND ACCELERATION SENSOR


7. INSTALL TIRE PRESSURE WARNING ECU


8. INSTALL TURN SIGNAL FLASHER ASSEMBLY


9. INSTALL REAR CONSOLE BOX ASSEMBLY

(a) Install the rear console box assembly (See page ).


10. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

(a) Install the lower No. 1 instrument panel airbag assembly (See page ).


11. ADJUST PARKING BRAKE SHOE CLEARANCE AND PARKING BRAKE PEDAL TRAVEL


12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).


Removal
REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS sys ...

Parking Brake Switch
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the n ...

Other materials about Toyota 4Runner:

Diagnosis System
DIAGNOSIS SYSTEM 1. DESCRIPTION (a) Air conditioning system data and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the Techstream to check for malfunct ...

Brake Booster Pump Motor on Time Abnormally Long (C1252)
DESCRIPTION The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU. DTC Code DTC Detection Condition Trouble Area ...

© 2016-2025 | www.to4runner.net

0.0145