INSTALLATION
PROCEDURE
1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY
(a) Install the spring and check ball body.
(b) Insert the pin of the manual valve into the hole of the manual valve lever. Text in Illustration
|
|
(c) Install the transmission valve body assembly with the 19 bolts. Torque: 11 N·m {112 kgf·cm, 8 ft·lbf} HINT: Each bolt length is indicated below. 36 mm (1.42 in.) for bolt A 25 mm (0.984 in.) for bolt B |
|
(d) Install the detent spring cover and detent spring with the bolt.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
2. CONNECT TRANSMISSION WIRE
3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY
4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
5. ADD AUTOMATIC TRANSMISSION FLUID
(a) Add automatic transmission fluid (See page ).
6. PERFORM RESET MEMORY
(a) Perform the RESET MEMORY procedures (A/T initialization) (See page ).
Installation
INSTALLATION
PROCEDURE
1. INSTALL VOLTAGE INVERTER ASSEMBLY
(a) Install the voltage inverter with the 3 bolts.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
(b) Connect the 2 connectors.
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
3. INSTALL FRONT DECK ...
Removal
REMOVAL
PROCEDURE
1. REMOVE UPPER RADIATOR SUPPORT SEAL
2. REMOVE FRONT BUMPER COVER
(a) Put protective tape around the front bumper cover.
(b) Remove the 3 bolts, 10 screws and 6 clips.
(c) Detach the 14 claws to remove the front bumper cover with ra ...